Panasonic HVAC Repair Cost (Sweden, 2026)
Estimates reviewed August 2026 · appliance-repair figures maintained by a licensed appliance technician.
Panasonic HVAC repairs typically run 1 100–26 400 kr, depending on the HVAC system, the problem, and your local labour costs. Panasonic is a premium brand — its parts are cheaper and widely stocked, keeping the parts side of a repair below the class average. Every figure is an Estimated range in kronor, never a fake precise number. Reviewed August 2026.
Panasonic repair cost by HVAC Estimated
These ranges apply Panasonic's parts tier (0.80× the mainstream baseline) to the parts portion only — labour is unchanged and localizes to your area. Tap an HVAC system for its full problem-by-problem breakdown and the localizer.
| HVAC | Estimated Panasonic range |
|---|---|
| Panasonic heat pump repair | 1 450–26 200 kr |
| Panasonic ductless mini-split repair | 1 100–26 400 kr |
| Panasonic thermostat & controls repair | 1 100–13 910 kr |
Base: published rates from 5 Swedish heat-pump and ventilation companies (2026-08) · Sweden national base range (SCB Lönestrukturstatistik 2024) · Reviewed August 2026 · Estimated
What changes a Panasonic repair bill
- Brand tier — Thirty Panasonic boards observed at jsenergi.com, SEK 2,034.00-6,960.00 incl. moms, median SEK 4,240.00 -- raw ratio 0.73 against SEK 5,807.00, below the 0.80 scale floor and therefore reported at 0.80. The gap is a board-class effect: a Panasonic split indoor/outdoor PCB is a physically smaller item than the hydronic heat-pump controller the anchor is built on. Tier stays premium: positioning and parts-price level are independent axes. The median above is drawn from a filtered set of 30 boards. Panasonic's full stable board category at the same retailer holds 3,027 items spanning SEK 1,317.00 (Kretskort SWDH) to SEK 21,506.00 (Pcb assy (rsf) 9231948020), so the 30-item figure is a sample of the split-board end of that catalogue, not a median of the whole category.
- Parts vs labour — the brand and tier shift the parts price; labour tracks your area's wage index, not the brand.
- The specific fault — a sensor, seal, or valve is far cheaper than a compressor, motor, or control board.
- DIY vs professional — Most Panasonic repairs are a professional job — this brand's parts and diagnostics usually need a qualified technician.
Panasonic error & fault codes
When a Panasonic HVAC system shows a fault code, the diagnosis — and the price — gets specific. The most looked-up Panasonic codes:
Panasonic H11 Panasonic H16 Panasonic H19 Panasonic H97 Panasonic H99 Panasonic F11 Panasonic F90 Panasonic F91 Panasonic F93 Panasonic F95 Panasonic F96 Panasonic F97 +16 more →
Common Panasonic problems
Panasonic split systems and ducted units present as error codes traced to sensors, indoor/outdoor PCBs, the outdoor fan motor or the inverter stage. Indoor heads show the class-typical condensate-drain blockage and blower-wheel fouling, appearing as dripping water or reduced, odorous airflow. Its Aquarea air-to-water heat pumps present hydronic-side faults around flow rate, sensors and defrost behaviour.
Is Panasonic expensive to repair?
Panasonic is a major Japanese manufacturer of split systems, ducted units and air-to-water heat pumps (Aquarea), sold widely in Europe, Australia and New Zealand. It is regarded as a mainstream brand with a standard inverter repair profile. It does not make gas furnaces or boilers. Genuine spares are distributed through Panasonic's regional networks and refrigeration wholesalers, with availability tracking the size of the local installed base. Electronics require genuine parts; some fan motors and universal components have aftermarket equivalents. Discontinued-model boards are the most likely source of a wait.
Estimated labour-cost-localized ranges — see the methodology for the localization method and named sources.
Reviewed by a Red Seal–certified appliance technician who also holds a Technical Safety BC gas ticket (Gas-C) and an ODS/halocarbon refrigerant ticket (CFC/HCFC/HFC).